DKC1500 SERIES SLIDING GATE OPERATOR USER
’S MANUAL
11
P
OSC
GND
G
T
K
P
OSC
GND
G
T
K
Pedestrian
Keypad
Com
Close button
Stop button
Open button
Schematic diagram
Wiring diagram
Control board External button switch
17. Transformer: 220V/10V 5W
9. Control
Button
3
Button
4
Button 2
Button 1
Fig.12
Adding extra remote controls (learn): Press the button
‘LEARN’ about 1 second(See Fig.12
terminal 9) on the control board, release the button till the
‘LED2’ turns on, then press the
same remote control button which you want to use twice, the
‘LED2’ will flash several times
and then turn off, The learning process is finished.
Up to 40 remote controls may be used.
Erase remote controls:
To erase all existing remote controls, press and hold ‘LEARN’
button about 8 seconds till
the ‘LED2’ turns on and turns off. This indicates that all the
remote controls have been erased completely.
Warning: For safety and security, we recommend that the factory setting be
replaced with a personal code.
The remote control works in three channel mode. See Fig.12. Button 1 - open the gate,
button 2-close the gate, button 3- stop the gate, button 4- pedestrian mode
Warning: Notify the users that the gate is never to be operated unless it is in full view.
Verify open direction: If the gate does not move in the desired direction, then you will need
to reverse the motor operating direction,
you can do this by exchanging wires
‘V’ and ‘W’,
‘OP’ and ‘CL’.
Exchange wires ‘OP’ and ‘CL’ if the limit direction is wrong.
WARNING:
Do not attempt to tune the gate by placing your hand, arm or other body part in the
