20
2e Determine
options
Input: * 5 # option # value #
option
value
0 send light switch protocol
0 = no, 1 = yes
(WE = 1)
3
acoustic
acknowledgement
buttons
0 = off, 1 = on
(WE = 1)
4 programming mode can only
be activated after the pro-
gramming mode of the control
unit was activated
0 = no, 1 = yes
(WE = 0)
The factory setting is valid for stand alone operation. To
improve the safety, activate the option 4 (putting the
value to 1) during the BUS operation. Thus, the access
to the control unit is an additional condition.
2f Block
manual
programming
Input: * 10 # master code #
master code = number with a maximum of 8 digits
The programming lock cannot be deactivated manually,
but only with configo
TM
.
Determine
the
extended code lock function
Input: * 12 # function type #
Function type:
0 = external contact has no influence
1 = contact must be opened so that the code input can be effective
2 = contact must be opened so that the code input can be effective
2g Change
master
code
Input: * 98 # old master code # new master code #
new master code #
new master code = number with a maximum of 8 digits
Change the pre-set master code when commissioning
the device.
2h
Reload factory settings
Input: * 99 # master code # master code #
master code = number with a maximum of 8 digits
All saved numeric codes are deleted. The master code
is reset to the factory setting.
Switch off the programming mode
2i
Quit the programming mode
Input: * 9 #
