12
Extended code lock function
You can only use the extended code lock function for the first code (memory location). The function can be
set with the configuration software configo
TM
.
You can connect a time switch (alternatively: motion detector, brightness sensor, door contact of a lock etc.) to the
bipolar pluggable screw terminal (contacts 1 and 2, see
Device overview
). The switching input at the terminals 1 and
2 can be configured (opening/closing contact) and influences the effectiveness of the code on the first memory loca-
tion.
The additional device effects the code entry.
Example:
In combination with a time switch access is only granted / not granted in the determined period of time,
depending on the configuration.
The programmed action is executed, if the code is entered correctly and the contact, according to the configuration
of the switching input, is effective.
Initial operation
WARNING! Danger to life due to electric shock
Observe the safety regulations according to DIN VDE 0100, when working on main power connections of
230 V.
►
Install the devices of the system voltage-free and completely.
►
Do not connect the video wires V1 and V2 with the P-, a- or b-wire. Observe the polarity when connecting the vid-
eo wires V1 (+) and V2 (−).
►
Proof the a-, b- and P-wire against each other on short-circuit.
►
Switch on the mains voltage.
Connect the floor push-button
►
Connect the floor push-button to the terminals E and P.
Alternatively you can connect the floor push-button to the terminals a and E.
Ensure that the a-wire of the power supply and control unit is connected to the a-terminal of the indoor
station.
Setting the volume of microphone and loudspeaker
CAUTION!
Device damage.
Use the enclosed small screw driver to adjust the volume!
