15
Bell button programming
Basic principle
All devices at the TCS:BUS have an unique serial number.
The serial number of the indoor station is allocated to the bell button of the front-door station. The allocation is
stored in the EEPROM of the front-door station.
Requirements for the programming:
►
Ensure that the access to the indoor station in the flat is granted.
►
Check if the indoor station is connected to the TCS:BUS.
►
Switch on the mains voltage. The operating LED at the power supply and control unit is on.
►
Check if no programming lock is set.
Before you can reprogram an already programmed bell button, you have to delete the programming.
Legend
press button shortly
busy tone
Press the button until...
a negative acknowledgement tone sounds
(bell button is already programmed)
release the button
SNapp-tone
go on
NoProg-tone (negative acknowledgement
tone)
ring tone
deletion tone sequence
Progsperr-tone
Prog2-tone (programming of the 2nd serial
number starts)
Audio files of the call and acknowledgement tones are available online at: www.tcsag.de/download/ruf-
und-quittungstoene
