58
Model C606
Operating Procedures
150415
Step 5
Holding the rear blade on the beater, slide it into the
freezing cylinder halfway. Install the front scraper
blade over the front holding pin. (See Figure 124.)
Figure 124
Step 6
Before installing the beater shoes, check the shoes
for any nicks, cracks, or signs of wear. If any defects
are present, replace the beater shoes.
Step 7
If the beater shoes are in good condition, install the
beater shoes. (See Figure 125.)
Figure 125
Step 8
Slide the beater assembly the rest of the way into
the freezing cylinder. Make sure the beater
assembly is in position over the drive shaft by
turning the beater slightly until the beater is properly
seated. When in position, the beater will not protrude
beyond the front of the freezing cylinder.
(See Figure 126.)
Figure 126
Step 9
Before assembling the freezer door, check the
following for any nicks, cracks, or signs of wear:
door bearing, door gasket, draw valve, o-rings, and
all sides of the door assembly, including the inside of
the draw valve bore. Replace any damaged parts.
Step 10
If the parts are in good condition, slide the 3 o-rings
into the grooves on the draw valve and lubricate.
(See Figure 127.)
Figure 127
Step 11
Lightly lubricate inside of the top of the freezer door
valve cavity. (See Figure 128.)
Summary of Contents for C606
Page 6: ...Table of Contents Model C606 Notes ...
Page 16: ...10 Model C606 Operator Parts Identification 140624 Front View Figure 2 ...
Page 26: ...20 Model C606 Operator Parts Identification 140624 Accessories Figure 11 ...
Page 30: ...24 Model C606 Operator Parts Identification Beater Door Assembly Shake Side Figure 14 ...
