13
Model 793
Important: To the Operator
Item #1 - MIX LOW Indicator Light
Located on the front of the unit is a mix level
indicating light. When the light is flashing, it indicates
that the mix hopper has a low supply of mix and
should be refilled as soon as possible. Always
maintain at least 3” (76 mm) of mix in the hopper. If
you neglect to add mix, a freeze-up may occur. This
will cause eventual damage to the beater, blades,
drive shaft, and freezer door.
Item #2 - MIX REF Key
When the MIX REF key is pressed, the light comes
on indicating the mix hopper refrigeration system is
operating. The MIX REF is controlled by the left side
of the unit as viewed from the operator end. The
MIX REF function cannot be cancelled unless the
AUTO or STANDBY modes are cancelled first.
Item #3 - STANDBY Mode Key
Per standard Chick-fil-A daily operating procedures,
the Standby feature is not used.
Item #4 - WASH Mode Key
When the WASH key is pressed, the light comes on.
This indicates beater motor operation. The
STANDBY or AUTO modes must be cancelled first
to activate the WASH mode.
Note:
To cancel a mode of operation function,
press the key again. The light and mode of operation
will shut off.
Item #5 - AUTO Mode Key
When the AUTO key is pressed, the light comes on.
This indicates that the main refrigeration system has
been activated. In the AUTO mode, the WASH or
STANDBY functions are automatically cancelled.
The MIX REF function is automatically locked in to
maintain the mix in the mix hopper.
Note:
To cancel a mode of operation function,
press the key again. The light and mode of operation
will shut off.
Item #6 - Power Switch
When placed in the ON position, the power switch
allows SOFTECH control panel operation.
Item #7 - Reset Button
The reset button is located in the service panel. The
reset protects the beater motor from an overload
condition. If an overload occurs, the reset
mechanism will trip. To properly reset the unit, press
the AUTO key to cancel the cycle. Place the power
switch in the OFF position. After two or three
minutes, press the reset button firmly.
Do not use metal objects to press the
reset button. Failure to follow this instruction
may result in electrocution.
Place the power switch in the ON position. Press the
WASH key and observe the unit's performance. If
the beater motor is turning properly, press the
WASH key to cancel the cycle.
Press the AUTO key on both sides of the unit to
resume normal operation. If the unit shuts down
again, contact an authorized Taylor service
technician.
Air Tube
Figure 5
After priming the unit, lubricate the o-rings on the
end of the air tube that has the small hole on the
side. Install that end of the air tube into the mix inlet
hole. Every time the draw handle is raised, new mix
and air from the hopper will flow down into the
freezing cylinder. This will keep the freezing cylinder
properly filled and maintain overrun.
Summary of Contents for 793
Page 47: ...Model 793 082065 33 Rev 6 13...
