31
6. Launch, step spar (if unstepped), connect rigging, bend on sails. Check all components prior to re-
installing them.
7. Reconnect coupling and check engine alignment.
8. If engine was drained, replace all drain plugs, tighten caps, and shut drain cocks. Fill and bleed
engine cooling system.
9. Fill fuel tank. Bleed engine fuel system per instructions in engine manual.
10. Replace hot water heater plug and reconnect water line at pump. Flush the fresh water system,
then fill the water tanks.
11. Clean and inspect engine and engine room equipment. Check oil levels throughout.
12. Clean interior thoroughly.
13. Check operation of all systems.
14. Install cushions, carpet, electronics, and other loose gear removed during winterizing.
15. Sea trial.
NOTE
: The check list provided in Section III-A will be a useful reference for the yacht's condition
after recommissioning.
Summary of Contents for VANCOUVER 42
