After Sales Support TEL: 1800 909 909 EMAIL: [email protected]
After Sales Support TEL: 1800 909 909 EMAIL: [email protected]
15
After Sales Support TEL: 1800 909 909 EMAIL: [email protected]
Drilling
Drilling metals
•
Always clamp sheet metal.
•
Support thin metal with a block of wood to avoid
distorting it.
•
Use a punch to mark the centre of the hole.
•
Use a suitable lubricant for the material you are
working on,
USE:
FOR:
Oil
Steel
Turpentine or paraffin
Aluminium
Do not lubricate
Brass, copper or cast iron
Drilling plastics and plastic coated chipboard
•
Use high speed drill bits
•
See drilling wood below
Drilling masonry
•
This drill is
NOT
designed for drilling masonry.
Drilling wood
•
Clamp a piece of scrap wood to the back of your work to
prevent splintering.
All drilling operations
•
Mark off the centre of the hole using a centre punch or nail.
•
Don’t force the drill, let it work at its own pace
•
Keep the drill bit sharp.
•
Reduce pressure, as the drill is about to break through
the item being drilled.
LED work light
When the unit is switched on, the LED work light (9) also
comes on to ensure better vision and to make working in
dark areas more safe. The working light goes out when the
On/Off switch is released.
CAUTION!
LED is laser class 1! Do not look directly into the
laser as this may result in damage to the eyes.
Chuck replacement
The chucks of reversible drills are always fixed by a screw
with a left-hand thread. The screw, which is located in the
centre of the chuck, must be removed before the chuck can
be removed. To remove the screw, turn it in a clockwise
direction. The chuck can now be removed by unscrewing it
anti-clockwise. If you have trouble removing the chuck take
the drill to your nearest authorised service centre for chuck
replacement.
CAUTION.
Always ensure that the drill is switched off
and the battery pack is removed before making any
adjustments.
Belt clip
The belt clip (10) is used to
assist to clip the tool to your
waist belt while working. Install
the clip to the drill by locating the
belt clip tabs in the slots in the
drill and tighten the screw to fix
the clip firmly.
