After Sales Support TEL: 1800 909 909 EMAIL: [email protected]
After Sales Support TEL: 1800 909 909 EMAIL: [email protected]
11
After Sales Support TEL: 1800 909 909 EMAIL: [email protected]
Important information – Product care
This drill/driver uses Lithium Ion Battery Cells. Care
MUST be taken to ensure both the safety and life of the
pack is maintained. Ensure you have read all of the safety
notes in the previous pages before using the drill/driver.
Treat the battery pack with care and within the guidelines
of this manual. If the pack does become immersed in water
or any fluids, or is subject to a sever drop etc, or it does not
operate within the guidelines of this manual, immediately
STOP using the battery pack and have it checked.
During operation avoid overloading the drill/driver. If
the drill driver is overloaded it will automatically STOP.
Overloading may occur for a number of reasons including
when the drill driver is pushed too hard or when using a
drill bit or attachment greater than what is specified. If you
do overload the drill driver during operation refer to the
“Overload” section in this manual.
Note:
When the battery of the drill is at the lower end of the
charge, the drill is more susceptible to the overload condition.
Running the drill at close to maximum load, or continual
resetting of the overload will cause the battery pack to
over heat. When a preset cell temperature is detected, the
battery pack will automatically STOP operating and will not
restart until the battery pack has cooled to a safe level.
In this condition, DO NOT force cool the pack by placing in
a freezer or similar device. Refer to the “
Overload
” section
in this manual.
Another feature of the drill/battery pack is the
low voltage
cut out
feature. This feature operates when the voltage
drops below a pre set value. When this occurs the tool will
automatically stop operating. To correct the situation you
need to either insert another charged battery into the drill
or recharge the existing battery, and then proceed with the
drilling/driving application.
Note:
Attempting to restart the tool in this condition without
either recharging the battery or installing a battery with
charge will lead to drill restarting and then stopping again
after only a few seconds of operation.
These safety devices have been fitted for the safety,
reliability and life of the tool.
Fitting and removing
the battery pack.
1. To install the battery pack
to the tool, align the raised
portion of the battery pack with
the grooves on the bottom of
the drill, and slide it firmly into
the handle until you hear the
battery release button snap
into place.
2. To remove the battery pack
from the tool, press the battery
pack release button and slide
the battery pack completely
out of tool handle.
When inserting the battery pack
into the charger, make sure
the pack is fully seated in the
charger.
To remove the battery pack from
the charger base, press the battery release button and slide
the battery out.
