MT HORIZONTAL MIXER WAGONS
USER’S MANUAL
Page
31
Different tags are shown here.
1
2
3
6
5
4
7
Note:
The numbers in the upper left corner of each
adhesive label are only used to identify them in this
manual. They do not appear on the actual labels located
below the distributors and control elements.
Figure 2.10 Control Symbols
The symbols shown above indicate the function of each distributor / control as follows:
1.
Unloading conveyor chain, forward-stop-rear
2.
Unloading door, open-close
3.
Folding conveyor, up and down
4.
Rear door loading (silo cutter models)
5.
Lift and lower cutter (silo cutter models)
6.
Activate beaters, on/off
7.
Cutter rotation (silo cutter models)
You can check in the following pictures the markers situated next to the distributor block and the
corresponding controls.
Figure 2.11 Monoblock Distributor Marking and Control Levers
