21
NOTE :
1.
For all other technical
requirements of side
protection device ref.
IS:14682:1999.
2.
Pitch ‘P1’, ‘P2’, ……..should
not be more than
1650 mm.
3.
Dimn ‘H’ is as measured on
the load bodies
manufactured by other
than Tata Motors supplied
load body.
4.
As per the regulations,
following Dimensions need
to be maintained within
the specified values.
4.1 Dimension ‘A’ should
be less than or equal to
300 mm measured
from front tyre rear
face (for LPT vehicles)
or less than or equal to
100 mm. measured
from rear wall of cab in
case of SFC vehicles.
4.2 Dimension ‘B’ should
be less than or equal to
550 mm measured
from ground.
4.3 Dimension ‘C’ should
be less than or equal to
300 mm measured
from front face of rear
tyre.
4.4 Dimension ‘G’ should
be greater than or
equal to 100 mm.
4.5 Dimension ‘D' should
be less than or equal to
350 mm measured
from lower most face
of floor structure.
4.6 Dimension ‘E’ and ‘J’
should be less than or
equal to 120 mm.
5.
Painting or powder coating
to be done for rust
prevention.
6.
All the members as shown
in drg. are with minimum
cross sections and thickness
required.
7.
Item no. 8 to be added at
the both ends to cover
item no. 7, to be welded to
both side guard panels.
8.
# This dimensions (460 mm
of item no. 1) to be
changed to meet
regulations given in sl. no.
4.2 (dimension `B') and 4.5
(dimension `D').
9.
Long side guards can be
provided with two pieces
with overlapping and with
suitable backing plate or
longitudinal gap of
maximum 25 mm is
allowed.
1.6 Additional fitments
General