TATA Motors Indigo eCS, Owner'S Manual & Service Book

Page: 130 / 166

128
MAINTENANCE & CAR CARE
HEADLAMP & HEADLAMP BULB REPLACEMENT
Head Lamps :
The head lamps are provided with two halogen lamps of
H1 (High beam) / H7 ( Low beam) type with single filament
for providing straight ahead illumination of the road for long
distance or a dip beam which illuminates the road
immediately ahead for short distance visibility. Use dip
beam to avoid inconvenience / blinding the drivers of
oncoming vehicles.
The head lamps must be properly aligned in order to obtain
maximum road illumination and reduced glare for oncoming
traffic. It is recommended to check alignment of head lamp
beams periodically at authorised service outlets
Head lamp focus adjustment should be always carried out
at the authorised service outlets with the help of screen
Head Lamp Bulb Replacement :
•
Switch 'OFF' the head lamps & ensure that the bulb is
not hot.
•
Open the bonnet and remove the lamp connector from
the head lamp bulb.
•
Remove rubber cap. Unlock the locking clip and take
out the bulb from the holder. This should be done
carefully, otherwise it may lead to breakage of the bulb
holder / holding clip.
•
Note the instructions on the bulb carton.
Replace the bulb with a new one of the same type with
right orientation in the holder.
•
Lock the clip, fit the rubber cap and fix the connector.
•
Switch 'ON' the head lamps and check the lighting.
CAUTION
Do not clean or touch the head lamp reflector as it will
damage the mirror finish of the surface.
1. Indicator Lamp
2. Rubber Cap
3. Low Beam Bulb
4. Rubber Cap
5. High Beam Bulb
6. Parking Lamp