Release 08/2020 Ver. 1.0
Installation Manual: Safety Edge
TAPESWITCH CORPORATION
100 Schmitt Boulevard
Farmingdale, New York, 11753
© 2020 Tapeswitch Corporation. All Rights Reserved
12
Tapeswitch edge mounting channel options - Figure 6
c. Drill through center of channel at desired intervals.
d. Position channels onto pre-determined machine location. Transfer drill if needed. Secure with flat or pan
head screws. See chart below:
Recommended fasteners for Edge mounting channels - Figure 7
FLAT CHANNEL TYPE
HARDWARE
104 Aluminum
106 Aluminum
TS-6, TS-16
TS-18
TS-26
TS-47, TS-48
TS-57
TS-8
FLAT HEAD, 6-32, X 1/2" MIN. LENGTH
TS-46
FLAT HEAD, 8-32, X 1/2" MIN. LENGTH
TS-67
PAN HEAD, 10-32, X 3/8" MIN. LENGTH
RECOMMENDED FASTENERS
PAN HEAD, 6-32, X 3/8" MIN. LENGTH
PAN HEAD, 8-32, X 3/8" MIN. LENGTH
