CLEANING SPARK ARRESTER
1.
Unscrew the
three
allen bolts (#
6
) securing the muffler end cap to muffler by using a
(
4mm
)
allen
wrench.
2.
Remove muffler end cap
(#
4
)
from muffler assembly.
3.
Unscrew the three allen bolts (#3) securing the spark arrestor by using a (5mm) allen wrench.
4.
Carefully remove the spark arrester
(#1)
from the muffler assembly.
5.
Remove accumulated carbon on the spark arrestor screen with soap and water and remove hard to remove carbon carefully with
a brass wire brush and then rinse and dry the spark arrestor.
6.
Check the spark arrestor for damage, and replace it if necessary.
7.
Re-install spark arrestor
(#1)
.
8.
Re-install spark arrestor mounting hardware (#2,3)
9.
Re-install muffler end cap
(#
4
)
on to muffler assembly.
10.
Re-install muffler end cap mounting hardware (#5,6) on to muffler assembly and tighten to the specified torque.
Be sure the exhaust pipe and muffler are cool before cleaning the spark arrester.
Tightening Torque:
Muffler End Cap
Bolts
: 6.77Nm / 5 ft/lbs
.
1.
Spark Arrester
2. Spark Arrester Lock Washer
3. Spark Arrester Mounting Bolt
4. Muffler End Cap
5. Muffler End Cap Lock Washer
6. Muffler End Cap Bolt
7.
Muffler Assembly
60
Summary of Contents for BULL 200s
Page 38: ...GETTING TO KNOW YOUR ATV 29 ...
Page 72: ...63 ...
Page 73: ...64 ...
Page 79: ...Find important product information and how to videos on our website www taomotor com ...
