NOTICE: When removing the engine oil drain
plug the oil filter retainer spring and oil screen
may fall out. Take care not to lose these parts.
NOTICE: Before installing the engine oil
drain plug
,
be sure to install the 0-ring
in clean
and in good working condition.
To change the engine oil
1. Engine Oil Drain Plug (17mm)
1. Oil Screen
2. Oil Screen Retainer Spring
3. Drain Plug
O-Ring
4.
Drain Plug
1. Place ATV on a level surface and set parking brake.
2. Place an oil pan under the engine to collect the used oil.
3. Remove engine oil filler cap (dipstick)
4. Remove engine oil drain plug to drain oil from the crankcase.
NOTE: When removing oil drain plug be sure not to drop retainer spring and oil filter screen.
4.
Clean oil filter screen and retainer spring with parts cleaner and let air dry.
5.
Reinstall drain plug, spring and screen to the specified torque (14 Nm / 10 ft/lbs
.
)
.
6.
Refill engine with specified amount of the recommended engine oil.
Recommended engine oil is SAE 15W-40 and oil capacity is 0.8 US qt. or 0.8 liters.
7.
Start engine and check for leaks.
8.
Turn off engine and wait for 10 minutes then check engine dip stick for correct engine oil level.
SAE Viscosity Grade and Outdoor Temperature Chart
48
Summary of Contents for BULL 200s
Page 38: ...GETTING TO KNOW YOUR ATV 29 ...
Page 72: ...63 ...
Page 73: ...64 ...
Page 79: ...Find important product information and how to videos on our website www taomotor com ...