Operating the Equipment Locally
Page 4-44
Instruction Manual: evolution 5000 E5710 and E5720 Encoder
ST.TM.E10074.1
Concatenation Option
4
Use this option if the signal has been coded, then decoded and is about to
be coded again. It reduces picture degradation associated with multiple
generation compression encoding. Setting this option may give better
results as it tries to line up the I-frames. Only available to video via the
SDI input. See Application Note, ST.AN.1110, Near Loss-less MPEG
Concatenation Without Helper Signals.
PID Option
The PID option is selected from the
Video Encoder Menu
by pressing the
PID softkey. The option is used for entering or updating video PIDs, as
required. Enter a PID then press the Enter softkey to accept it.
To be DVB compliant, PIDs below 32 are reserved. Therefore PIDs 32 to
8191 are available for use. In the event of a clash, one of the PIDs will be
changed by the Encoder’s internal checking algorithm.
PID
¬
Left
PID :
+
®
Right
`33 (0021h)’
—
l
Ins
Enter
l
l
Del
Update using softkeys
Quit
l
Reflex Enable Option
The Reflex Enable option is selected from the
Video Encoder Menu
by
pressing the Reflex Enable softkey. The option is used to enable (On) or
disable (Off) Reflex.
Copyright Option
This option indicates whether the information in the bit-stream is shown to
be protected by copyright. It is for status only and cannot be changed.
Original Option
This option indicates whether the bit-stream is an original or a copy of an
original bit-stream. It is for status only and cannot be changed.
Encoder Type Option
This option indicates the type of Encoder. It is for status only and cannot
be changed.
S/W Release Option
This option indicates the software release of the Encoder. It is for status
only and cannot be changed.
4
Auto Concatenation is only available when software option M2/ESO2/ACON is purchased.
