Introduction to the Basic Encoder
Instruction Manual: evolution 5000 E5710 and E5720 Encoder
Page 1-3
ST.TM.E10074.1
1.1
Scope of this Manual
1.1.1
Who Should Use This Manual
This manual is written for operators/users of the E5710 (1U) and E5720
(2U) Encoders to assist in the installation, operation and day-to-day care.
These Encoders are referred to throughout this manual as ‘Encoder(s)’
unless there is a specific difference, where they will be referred to by the
model number.
The Encoder may be used as part of larger systems (see Section 1.3.5,
Control and Monitoring) as well as in systems from other suppliers. It may
also be used as a stand-alone unit to output a complete transport stream
into Satellite or Telecom networks.
WARNING…
DO NOT REMOVE THE COVERS OF THIS EQUIPMENT. HAZARDOUS VOLTAGES ARE PRESENT
WITHIN THIS EQUIPMENT AND MAY BE EXPOSED IF THE COVERS ARE REMOVED. ONLY
TANDBERG TELEVISION TRAINED AND APPROVED SERVICE ENGINEERS ARE PERMITTED TO
SERVICE THIS EQUIPMENT.
CAUTION…
Unauthorised maintenance or the use of non-approved replacements may affect the equipment
specification and invalidate any warranties.
This manual does not include any maintenance information or procedures
which would require the removal of covers.
1.1.2
Build Version
This manual has been written to cover the functionality in Table 1.1.
Table 1.1: Build Version
E5710
E5720
Build Version
2.0.0
2.0.0
The Build version indicates the status of the Encoder and refers to an
overall number which encompasses all the various software/firmware
versions of video, audio, etc. in the Base Board.
The current Build version can be found in the
Build Menu
(see Chapter 4,
Operating the Equipment Locally, Figure 4.9).
This number should be
quoted in all correspondence with TANDBERG Television.
This manual continues to be relevant to subsequent Build versions where
the functionality of the equipment has not changed. When a new issue of
the Build version changes the functionality, a new issue of this manual is
provided.
