Chapter 2 Installing the Tape Drive
Installing the Device Drivers
DLT-V4 Product Manual
34
7
At the “Install From Disk” view, click
Browse ...
, and then locate the
folder where you saved the driver files. Select the “QntmDLT.inf” file
in that folder, and click
Open
.
8
At the “Install From Disk” view, verify that the drive letter and path
shown are correct. Then click
OK
.
9
In the next view, highlight the Tandberg Data DLT-V4 tape drive, and
then click
Next
. The “Start Device Driver Installation” view is displayed.
10
Click
Next
to install the driver.
11
The next view is “Completing the Upgrade Device Driver Wizard”.
Click
Finish
. You may be prompted to reboot your system.
The DLT-V4 device driver is installed.
Note:
If the Wizard should indicate that a driver already exists on
the system and prompts you for a selection, select
New
. When
the Windows 2000 Setup window is displayed, verify the
correct path to the driver, and then click
Continue
.
