Chapter 2 Installing the Tape Drive
Installing the Internal SCSI Tape Drive
DLT-V4 Product Manual
14
Installing the Internal SCSI Tape Drive
2
This section contains step-by-step instructions for installing the internal
SCSI tape drive.
Identifying the Steps
2
Installing the tape drive is fast and easy when you follow the instructions
in this section in the order presented. Complete the following steps,
covered in the next few sections:
Table 2 Installing the DLT-V4
Internal SCSI Tape Drive —
Overview
Step
Instruction
Refer to
1
Unpack and check the tape drive for shipping
damage.
page 15
2
Select a server or workstation that is to host
the tape drive.
3
Set the SCSI ID for the tape drive, if you do
not want to use the factory-set default.
page 16
4
Shut down and power off the server or
workstation that is to host the tape drive.
Power off all peripheral devices attached to
the server or workstation.
5
Install an active LVD/SE terminator on the
SCSI cable if the tape drive is the last or only
device on the SCSI bus.
page 17
6
Remove the cover from the server or
workstation, as explained in the server or
workstation’s documentation
page 19
7
Install an LVD/SE SCSI host adapter in the
server or workstation, if necessary.
8
Install the tape drive in an open drive bay.
page 19
