DLT-V4 Product Manual Guide
4
Chapter 2
2
Installing the Tape Drive
This chapter explains how to configure and install the tape drive.
Configuration and installation are not difficult and require only that you
follow the instructions presented in this chapter.
Preparing to Install the Tape Drive
2
This section helps you prepare to install the DLT-V4 tape drive (tabletop
or internal).
Before You Start
2
Installing the DLT-V4 SCSI tabletop tape drive requires no special tools.
For the SCSI interface, you will need a ballpoint pen to change the SCSI
ID switch on the rear panel of the tape drive.
If you are installing a DLT-V4 SATA internal tape drive, see
Installing the
Internal SATA Tape Drive
on page 25 for instructions. Installing the DLT-
V4 internal tape drive requires only the usual tools needed to install an
internal tape drive in the computer you have chosen to house the tape
drive (for example, a screwdriver and some ESD protection).
SCSI Bus Requirements
2
The DLT-V4 SCSI interface tape drive (tabletop and internal) incorporates
a wide Ultra160 low-voltage differential (LVD) small computer system
