9
English
6
5
Fig. 3
○
The cutting head must be securely mounted to
the unit’s gear case.
○
If the cutting head does not feed cutting line
properly, check that the nylon line and all
components are properly installed. Contact
Tanaka dealer if you need assistance.
WARNING
For Tanaka heads, use only
fl
exible,
non-metallic line recommended by the
manufacturer. Never use wire or wire ropes.
They can break o
ff
and become a dangerous
projectile.
3. Installation (Fig. 4)
Insert the allen wrench (7) into the hole of the
gear case in order to lock the drive shaft tube.
Install cutting head on gear case of grass
trimmers. The mounting nut is left-hand-
threaded. Turn clockwise to loosen/counter-
clockwise to tighten.
7
Fig. 4
4. Adjusting line length
Set the engine speed as low as possible and tap
the head on the ground. The nylon line will be
drawn out about 1-3/16
˝
(3 cm) with each tap.
(Fig. 5)
Fig. 5
Also, you can extend the nylon line by hand but
the engine must be completely stopped. (Fig. 6)
Fig. 6
Adjust the nylon line to the proper length
of 4-11/32
˝
–5-1/2
˝
(11–14 cm) before each
operation.
OPERATING PROCEDURES
Fuel (Fig. 7)
Fig. 7
WARNING
●
The trimmer is equipped with a two-stroke
engine. Always run the engine on fuel, which
is mixed with oil.
Provide good ventilation, when fueling or
handling fuel.
●
Fuel contains highly
fl
ammable and it is
possible to get the serious personal injury
when inhaling or spilling on your body.
Always pay attention when handling fuel.
Always have good ventilation when handling
fuel inside building.
000Book̲TCG24ECP(SL)̲NA.indb 9
000Book̲TCG24ECP(SL)̲NA.indb 9
2016/02/04 9:59:55
2016/02/04 9:59:55
