English
Locomotive decoders of the series 30 plus
Problems in analogue mode
The locomotive does not run in analogue mode, the decoder does
not work.
Possible cause: The analogue mode is switched off.
Alter the
value for CV#29.
The decoder does not switch to analogue mode (or switches over
although it is still digitally controlled).
Possible cause: The value in CV#11 is set too high or too low.
Alter the value and check the settings in operation.
Problems with switching of the functions
An accessory / a light does not react to switching commands.
Possible cause: The accessory is defective or incorrectly connected.
Check the accessory / the connections.
Possible cause: The output is defective (e.g. due to overload or short
circuit).
Send in the decoder for check / repair (with costs).
The lighting goes on and off when the speed levels are turned up or
the lighting cannot be switched on or off.
Possible cause: The speed mode of the decoder and the digital control
unit do not correspond. Example: The central is set to the mode 28
speed levels, but the decoder to the mode 14 speed levels.
Change
the speed mode at the central and / or at the decoder.
Problems with switching via switching inputs
After passing a permanent magnet in the rails no function is
activated.
Possible cause: The reed contact or the Hall sensor has been
mounted incorrectly.
Check the connections.
Possible cause: The distance to the magnet is too large or the
magnet is too weak.
Alter the position of the magnet (if possible)
or use a stronger one.
Page 84