English
Locomotive decoders of the series 30 plus
Starting
the programming mode
Programming the decoder
1. Switch on the central unit or
perform a reset at the central
unit (pushing "stop" and "go"
simultaneously).
2. Set the current decoder
address (default value: 3) or
the address "80".
3 Set all functions to "off".
4. Push button "stop"
à
switch off the track voltage.
5. Operate the direction switch
and hold it in that position.
Push the button "go" at once.
6. As soon as the lighting
flashes, release the
direction switch.
1. Enter the number of the
register as a Motorola-address.
If necessary: with a leading "0".
2. Operate the direction switch.
à
Lighting flashes faster.
3 Enter the value you want to
set into the register
(as Motorola-address).
4. Operate the direction switch.
à
Lighting flashes more slowly.
Repeat steps 1 – 4
for all registers.
Push button "stop".
à
Programming mode
à
End of programming mode.
Programming with central units with restricted input options
Some central units do not allow but input values up to 80 or 99. Two
auxiliary registers (CV#26 and #30) make it possible to enter higher values.
Programming with the Central Station and the Mobile Station
With the Central Station I or the Mobile Station of Märklin** you can
program the registers. Select the article no. 29750 from the locomotive
database and program the decoder as described for this article in the
Central Station´s or Mobile Station´s manual.
Page 56