Takeuchi TL150, Workshop Manual

Page: 85 / 312

III-42
MACHINE CONFIGURATION
ATTACHMENTS
INSPECTION AND ADJUSTMENT
Adjusting the Bucket Stopper
DANGER
When the lift arm is raised, never position your-
self under it without making sure that the lift
arm is securely supported by the lift arm stop-
per.
For the adjustment, the pin hole (1) of the lift arm
must be supported by the arm stopper (2) at the
height of approximately 1600 mm above the ground.
The following arm stopper (2) and lock pin (3) must
be prepared for safety operation.
Arm Stopper (2)
Part Number Quantity
08819-63750 1
Lock Pin (3)
Part Number Quantity
08816-02700 1
Installing the Arm Stopper
Install the arm stopper (2) to support the lift arm in
place for adjusting the bucket stopper.
1. Park the machine on a flat and rigid ground, and
remove the bucket.
2. Lower the lift arm to its lowest position, and
stop the engine.
3. Hook the arm stopper (2) on the steel bar (4) of
the lift arm, and place it on the cylinder.
4. Start the engine, and raise the lift arm until the
arm stopper (2) falls on the cylinder rod.
WARNING
• Park the machine on a flat and solid ground
for work.
• Be sure to be seated on the cab when oper-
ating the machine, including the starting and
stopping the engine.
• Set the engine speed to low when operating
the control lever.