TAKASAGO ZX-S-LN Series, Instruction Manual

Page: 68 / 204

Using via Digital Data Communication
------------------------------------------------------------------------------------
65
Change of Setting (Maintenance Mode), IP Address etc
Change the network settings of this product, using the terminal emulator(hyper terminal etc.) from PC.
In this case, the operation of the product changes over from the usual operation to the maintenance mode.
■Transition Procedure from LAN port to Maintenance mode
①Connect PC to LAN port by connection cable, then power on the product.
②Connect by PC to IP address「192.168.0.1」, port 23 of this product(active-open)
③ 「 Display Ex.1 」 is displayed, when the connection is established(ESTABLISHED), and chages to the
maintenance mode.
MM-2490 : ZX-S series LAN I/F
version : 0.00 (build: Jan 01 2012, 00:00:00)
Copyright(c) TAKASAGO,LTD. 2012 All Rights Reserved.
（Display Ex.１)
・The connection which has been already connected as the usual operation is cut.
・Restart the product, in case that reflects the setting change and terminates the maintenance mode.
・Can not operate as a usual interface converter, during operating in the maintenance mode.
・Do not forget to save by 「S」command, after settings change.
・Do not power off the product, till 「save E2PRO．．．Done.」 appears on the display, after saving the settings
change.
Caution

If IP address of this product is forgotten after its change, please follow the default settings described in Pgae 18.
The network settings are initialized by default settings of this product(press A+C, then start up)
※MAC address is not initialized.
Please refer to Page 67 about the default value of network settings.
Initialization of IP Address