Tadiran Telecom Aeonix TGW SIP-PRI Series, User Manual, Page: 11 / 61

TGWxE1 G a te w a y S e rie s U s e r M a n u a l
Ta d ira n Te c h n o lo g ie s , In c . 1 - 3
Label Description
ETH
Specifies an RJ45 module interface.
Interfaces ETH1 and ETH2 share the same IP address for allowing access to the external
network. Dual-LAN redundancy is supported.
AUX
An RJ45 interface.
Interfaces AUX1 and AUX2 share the same IP address for local management and
configuration.
T1/E1
An RJ45 interface, in support of 1 T1/E1, 2 T1/E1, and 4 T1/E1. Each T1 interface
supports the maximum 24 voice channels; each E1 interface supports the maximum 30
voice channels with ISDN PRI signalling.
SD A SD card socket.
Table 1-2 Indicators
Label Function Status Description
PWR
Power
Indication
Green Power on
Off Power off
STU
Status
Indication
Off System failed and inactive
Red Flash
System is in a diagnostic mode and you canexecute limited operation
(e.g. Log in to system through Telnet)
SteadyRed System is powered up and not operating normally yet.
Green Flash System is operating normally
ALM
Alarm
Indication
Green No alarms
Red Flash New alarms occurred
Red Alarms existed
ETH
Interface state
indicator
Green on The transmit speed is 1000M bit/s.
Green off The transmit speed is 10M bit/s or 100M bit/s.
Yellow on The link has been established but no service traffic is transmitted.
Yellow flashing Service traffic is being transmitted on the link.
Yellow off The link is not established.
AUX
Interface state
indicator
Green on The transmit speed is 1000M bit/s.
Green off The transmit speed is 10M bit/s or 100M bit/s.
Yellow on The link has been established but no service traffic is transmitted.
Yellow flashing Service traffic is being transmitted on the link.
Yellow off The link is not established.
T1/E1
Interface state
indicator
Long green The connection works normally.
Blinking red A remote alarm is generated.
Long red A local alarm is generated.
Off No connection is established.