Tadano GT-550E-2, Operation And Maintenance Manual

Page: 87 / 100

2.
Press the outrigger mode select key in conformity
with the actual outrigger extension width.
◆ Each time the outrigger mode select key is pressed,
the status changes in numerical sequence, from (1) to
(6), as shown below. The display returns to (1) if you
press the switch when status (6) is displayed on the
screen.
◆
When the front, rear, right and left outrigger extension
widths differ, select the smaller width.
◆ The outrigger state indicative symbol is switched with
flashing.
3.
After selecting the intended outrigger status and
front jack status, press the register key to register the
status. The outrigger state indicative symbol will stop
flashing and become marked up.
4.
Register the lift status.
◆
See “Selecting Lift Status” section.
T038300E
51
AML (Overload Prevention Device) AML (Overload Prevention Device)
(6) Outriggers fully extended
Front jack extended
(3) Outriggers fully extended
Front jack not used
(5) Outriggers extended halfway
Front jack extended
(2) Outriggers extended halfway
Front jack not used
(4) Outriggers not extended
Front jack extended
(1) Outriggers not extended
Front jack not used
T30139E
％
t
m
max t
m
m
T24099E
Register key
Front jack mode
indicative symbol
Outrigger state
indicative symbol
Outrigger mode select key