Start the Engine from the Operator’s
Cab Only
If the engine is started from any location other than
the crane operator
’
s cab, it can become impossible
to avoid a dangerous hazard if some machine action
is initiated when the engine turns over.
Start the engine only from the operator
’
s seat.
Inspection after Starting the Engine
Failure to perform a basic inspection after starting
the engine can result in not detecting fault or abnor-
mality with the machine.
Inspect the machine in a safe location that is free
from obstacles and people other than maintenance
personnel.
Allow the engine to warm up after it is started while
the instrument readings and checking the machine
components. Once the engine is properly warmed
up, make a safety check of the work area, and run
the machine without a load to check out condition of
the controls, machine elements and safety devices.
Warm Up the Machine
Failure to properly warm-up the engine and various
other machine components can result in decrease in
service life of the machine or malfunctions. In win-
ter, run the engine for at least five minutes for
proper warm-up.
Then, run the engine at low speed without a load to
warm up the hydraulic oil and other machine com-
ponents.
Night Operation
Operation in the dark makes it difficult to ensure
good footing, and to locate nearby persons or ob-
stacles, increasing the probability of an accident.
When operating at night, turn on all working lamps.
Provide ancillary portable lighting equipment to illu-
minate the work area.
Keep the Engine Clean
Dead leaves, paper dust and oil stains on and
around the engine can catch fire. Remove all such
debris before commencing operation.
Keep Unauthorized Personnel Away
from the Work Area
Unauthorized personnel or vehicles in the work area
can result in collision accidents, injury or death.
Before operation, make sure there are no unautho-
rized personnel or obstacles within the work area.
If the work area is situated near heavy traffic, post a
control person to prevent vehicular accidents.
Barricade the work area with appropriate means ei-
ther colored tape or rope.
T019605E
A-5
Safety Rules
Safety Rules
T00020
T01937E
DANGER
STAY CLEAR
Summary of Contents for GT-550E-2
