Page 7
The Build
Please Note: Few pictures shown below are of different plane and for reference purpose only.
7. Locate the 3mm X 660mm CF Spar shown in the picture above
8.Apply a thin layer of HV Cyno on CF Spar, and glue it on the leading
edge of wing, like shown above.
9. Make sure to lay down the wing on the flat surface while glueing the
CF stripe.
10. Turn back the wing to glue down the reinforcement rods, if needed
use a scissor or a ball point pen to loosen down the pre cut laser lines.
11. For rear wing re-inforcement,insert the supplied 1mm rod into the
pre cut slot. (Check the page 4 of exploded view for more clear idea)
12. Make sure it is completely inserted into the slot.
8
9
11
12
7
10
10
3X1X660MM
1mm Rod
