The Build
Please Note: Few pictures shown below are of different plane and for reference purpose only.
79
ends, to insert the rods into.
. Locate the pre cut small slits on the wing tips, 2 slits on both the
80. Do not use any glue until the step that calls for it. The object will be
for the rods to be installed as shown above. Start by making sure the
wing is flat.
81. The last ends of the two pieces should engage into the slots just
behind the undercarriage.
82. Route them thru the slits in the truss brace. They will fit down into
the slit about 1/8 inch.
83. Position the carbon rods for the other wing and then at each of the
points where the carbon and foam meet, put a drop or two of thin CA
and set with kicker.
84. Up Next is the fuselage trussing. Locate the pre cut small slots all
over the tail, horizontal and vertical profile sections.
79
81
80
82
83
84
Page 19
