The Build
Please Note: Few pictures shown below are of different plane and for reference purpose only.
37. Repeat the process where it attach to the wing as well.
38. Install the 1mm carbon rod to reinforce the tail section as shown
above.
39. Again you need to cut the required length from the supplied
1000mm rod or from any excess remaining rod from the previous
steps.
40. The horizontal piece of the fuselage also uses the 1mm carbon fiber
rod spanning the entire length from the rear wing spar to the horizontal
stab spar, cut the required length and insert the rod into the precut slot
like shown above.
41. Make sure everything is flushed, Use a thin CA to glue it.
42. Hit with kicker and verity that there is a good solid bond, if there are
loose areas simply add a little more CA and Kicker.
37
39
41
40
38
42
1mm Rod
1mm Rod
REGULAR THIN
CYNO ONLY
Page 12
