The Build
Please Note: Few pictures shown below are of different plane and for reference purpose only.
109. Repeat the process for other side. Above is the finished linkage
setup with aileron centered and rod well fitted and glued in both the
quick links.
110. Locate the 1.2mm control links for elevator and rudder.
111. Elevator linkage, Make sure you have the servo centered before
moving further with the setup, check the orientation shown in the above
image.
112. Screw the 1.2mm dia control links over the both elevator control
horn and servo arm as shown above.
113. Before moving to elevator linkage setup, glue 4pcs pushrod
guide into the pre cut slots.
114. Notice how the elevator rod is slid in the pre glued pushrod
guides, Glue the Elevator control rod on the one side, using thin CA or
optionally HV CA.
109
111
110
112
113
114
REGULAR THIN
CYNO ONLY
Page 24
