The Build
Please Note: Few pictures shown below are of different plane and for reference purpose only.
133. Cut down the 2 pieces 65mm length rod from the supplied 1mm
rod, and glue them in place like shown in the above image for motor
mount reinforcement.
134. Above is the finished linkage setup with rudder centered and rod
well fitted and glued in both the quick links with all the guides in place.
Use the same process like we did in previous linkage setups.
135. Shown above is the motor mount glued, making sure everything
is flush and lined up correctly. After that Install the motor on it.
136. Enlarge the pre cut holes over the mount according to need and
install the motor on it.
137. Notice above the plate glued onto the side of the fuselage. This
can be used to mount the electronic speed controller.
138. Notice above the plate glued onto the side of the fuselage. This
can be used to mount the electronic speed controller.
133
135
134
136
137
138
1X65mm Rod
Page 28
