Tools and components required for assembly
To complete the TS 120cc Edge/Slick/Extra you will require the following tools: -
Hobby knife with a selection of sharp blades
Electric drill & various drill bits
Covering iron/heat gun
Needle files
Adjustable spanner
Small flat head and Philips screwdrivers
Allan keys/drivers (1.5/2.5/3/4mm)
Sandpaper and block
Pliers
Various sockets (optional)
Ruler and Calliper gauge
Various adhesives: -
5 minute epoxy
30 minute
epoxy
Thin and
medium Cyano
Silicon sealant
Blue Loctite
Isopropanol alcohol
Hardware components required: -
100 – 120cc engine with mufflers/canisters/tuned pipes to suit
Propeller to suit your engine
9 high torque digital standard sized servos (HV recommended)
o
4 servos minimum are required for the ailerons (6 optional, 3 per aileron)
o
2 servos are required for the elevators
o
2 servos are required for the rudder
o
1 servo is required for the throttle
Servo arms: -
o
6no 1.75” arms for ailerons and elevators (8no if 3 servos/wing setup used)
o
2no 2” arms for a push/pull rudder setup*
o
1no 1.75” single and 1 no 3.5” double arm for a pull/pull rudder setup*
o
*See the Rudder section of the manual for in depth details of these options
1no 1 litre fuel tank
1no Fuel dot
1m Tygon or similar fuel
tube
Radio gear
Ignition and receiver batteries
Spinner bolt to suit your
engine
Summary of Contents for TS 120CC Slick
Page 1: ...Instruction Manual for TS 120CC Slick Edge Extra...
Page 5: ...3...