SystemAir Danvent DV, Annex For The User Manual

Page: 73 / 76

Annex 12—5
12.4 Set ‐ up Danfoss FC101 for DV ‐ units with PM motors
SETUP IS DONE IN FACTORY BEFORE DELIVERY
To reload Systemair factory settings from the control panel:
0 ‐ 50: LCP Copy: [2]
Systemair factory set ‐ up is based on Danfoss initialization.
14 ‐ 22: Operation mode: [2] Initialisation (Danfoss Initialisation)
Turn power off and on.
Systemair factory set ‐ up:
0 ‐ 01: Language selection:
1 ‐ 06: Clockwise Direction: [1] Inverse
1 ‐ 10: Motor Construction: [1] PM, non ‐ salient SPM
1 ‐ 24: Motor Current: According to motor plate / Schedule
1 ‐ 25: Motor Nominal Speed: According to motor plate / Schedule
1 ‐ 26: Motor Cont. Rated torque: According to motor plate / Schedule
1 ‐ 30: Stator Resistance (Rs): According to motor plate / Schedule
1 ‐ 37: d ‐ axis inductance (Ld): According to motor plate / Schedule
1 ‐ 39: Motor Poles: According to motor plate / Schedule
1 ‐ 40: Back EMF at 1000 RPM: According to motor plate / Schedule
1 ‐ 42: Motor Cable Length: 3m
1 ‐ 90: Motor Thermal Protection: [2] Thermistor trip
3 ‐ 15: Reference 1 Source: [2] Analog input AI54
1 ‐ 93: Thermistor Source: [1] Analog input AI53
3 ‐ 03: Maximum Reference: According to motor plate / Schedule
3 ‐ 16 + 3 ‐ 17: Reference 2 ‐ and 3 Source: [0] No function
3 ‐ 41 + 3 ‐ 42: Ramp 1 Up and down: 30 sec.
4 ‐ 19: Max. Output Frequency: According to motor plate / Schedule
4 ‐ 14: Motor Speed High Limit: According to motor plate / Schedule
4 ‐ 18: Current limit: 115 %
5 ‐ 12: Terminal 27 Digital input: [0] No operation
5 ‐ 40.0: Function Relay: [3] Drive ready/remote
5 ‐ 40.1: Function Relay: [3] Drive ready/remote
6 ‐ 25: Terminal 54 High Reference: According to motor plate / Schedule
14 ‐ 03: Over modulation: [1] Active
14 ‐ 20: Reset Mode: [2] Automatic reset x 2
0 ‐ 50: LCP Copy: [1] All to LCP (Copy of Systemair factory settings to panel)
Connections:
0 ‐ 10V: terminal 54 ‐ 55
Start: terminal 12 ‐ 18
Thermistor: terminal 50 ‐ 53
Drive ready: terminal 1 ‐ 2