!
79
2. Press the CHG Key to begin decimal data modification.
CHG
PRES VAL?
c000 65520
3. Input the new PV and press the WRITE Key to change the PV. The operation
will end and the decimal-without-sign monitoring display will return when the
WRITE Key is pressed.
The PV can be set within a range of 0 to 65,535.
D
3
C
2
7
6
8
WRITE
c000
32768
Press the CLR Key or the SHIFT and TR Keys to return to the normal moni-
toring display.
If an erroneous input has been made, press the CLR Key to restore the sta-
tus prior to the input. Then enter the correct input.
1-3-23 Force Set, Reset
This operation is used to force bits ON (force set) or OFF (force reset) and is
useful when debugging the program or checking output wiring. It is possible
in MONITOR or PROGRAM mode only.
RUN
MONITOR
PROGRAM
No
OK
OK
Caution
Check that there is no effect on equipment before using force set/reset.
1, 2, 3...
1. Monitor the status of the desired bit according to the procedure described in
1-3-11 Bit, Digit, Word Monitor
. If two or more words are being monitored,
the desired bit should be leftmost on the display.
(Multiple address monitor)
00000 20000
^OFF ^ON
2. Press the SET Key to force the bit ON or press the RESET Key to force the
bit OFF.
SET
00000 20000
ON ^OFF
The cursor in the lower left corner of the display indicates that the force set/
reset is in progress. Bit status will remain ON or OFF only as long as the key
is held down; the original status will return one cycle after the key is re-
leased.
3. Press the SHIFT+SET or SHIFT+RESET Keys to maintain the status of the
bit after the key is released. In this case, the force-set status is indicated by
an “S” and the force-reset status is indicated by an “R.”
To return the bit to its original status, press the NOT Key or perform the Clear
Force Set/Reset operation. Refer to
1-3-24 Clear Force Set/Reset
for de-
tails.
Forced status will also be cleared when the PLC’s operating mode is
changed (unless SR 25211 is ON, in which case forced status will not be
cleared when changing from PROGRAM to MONITOR mode) or when op-
eration stops as the result of a fatal error or power interruption.
1-3-24 Clear Force Set/Reset
This operation is used to restore the status of all bits which have been force
set or reset. It is possible in MONITOR or PROGRAM mode only.
RUN
MONITOR
PROGRAM
No
OK
OK
Programming Console Operations
Section 1-3
Summary of Contents for CPM1A-20CAR-A
