伺服產品
/Servo Products
–
Hardware Manual of 380V 7.5kW Servo Drive II (SPD-32C1-075)
Wiring and Signal (SPD-32C1-075)
–
50
11.8 Connector and Terminal Definition (SPD-32C1-075)
Name
Terminal code
Description
Main circuit power input terminal
R
、
S
、
T
Connect three-phase AC power
Control board power
L1, L2
L1, L2 can be connected or not connected,
according to the wiring plan
Motor power input terminal
U
、
V
、
W
Connect the motor
Regenerative resistor terminal
P
、
B2
Use an external regenerative resistor
Serial servo communication
M3A, M3B
Connect to the host controller
USB port
mini USB
Connect to the USB port of a PC
Universal servo signal IO
Connect to the host controller
Safe Torque Off(STO)
STO port
First encoder feedback
ENC1
Connect to the motor encoder
Second encoder feedback
ENC2
Connect to the load encoder
Ground terminal
connected to the ground
Wiring Precautions:
Keep the six power lines R, S, T and U, V, W away from other signal lines, at least a 30 cm distance if possible.
When the power is cut off,
the drive's internal capacitor still contains a large amount of charge--
do NOT
touch the six power lines R, S, T, and U, V, W. Please wait until the charging light goes out.
When lengthening the encoder cable, apply twisted pair cabling to the encoder cable and the grounding
signal cable. Do not exceed a length of 20 m (65.62 in or 14 ft); if it is absolutely necessary to do so, please use
a signal line with twice the wire diameter in order to minimize signal attenuation.
Please wire according to relevant regulations. Select the wire diameter according to motor wattage, as
follows:
