Symmetricom TimeProvider 500, User Manual

Page: 98 / 174

98 TimeProvider 500 2.0 User’s Guide 098-00172-000 Revision A – December, 2009
Chapter 4 CLI Commands
Set Alarm Commands
This command sets the VLAN parameters for interfaces 1 – 4. The following rules
apply to this command:
Syntax:
set vlan-config [if1|if2|if3|if4] vlan_id <v lan-id > priority
< vlan_priority >
Range:
vlan_id = [1, 2,3 …, 4094]
vlan_priority = [0, 1, …,7]
Default :
if1: vlan_id = 2
if2: vlan_id = 3
if3: vlan_id = 4
if4: vlan_id = 5
vlan_priority = 0
Example:
Sets VLAN ID to 22 and priority to 6.
set vlan-config 22 priority 6
Response:
VLAN ID set to 22 and priority to 6
Set Alarm Commands
The set alarm command set allows you to enable or disable reporting of selected
alarms, configure the severity level of alarms, and the delay before an alarm is
reported. Alarm number mapping is shown in
Table 5-3 .
Note : The
set configuration factory
command will reset this
setting. The
set configuration default
command will not
change the current setting.
Note : These settings will only be used when the interface configured
for VLAN is enabled using the
set interface
command.