Symmetricom TimeProvider 500, User Manual

Page: 94 / 174

94 TimeProvider 500 2.0 User’s Guide 098-00172-000 Revision A – December, 2009
Chapter 4 CLI Commands
Set Commands
set ip-mode
This command has changed in version 2.0 to support DHCP.
This command configures the addressing mode for the available connection method
for TimeProvider 500. Setting the connection method to
static will use the address
from the
set ip
command. Setting the connection method to dhcp enables the
connection method to obtain an address from a DHCP server.
Syntax:
set ip-mode [all|if0|if1|if2|if3|if4] [static|dhcp]
Default:
ip-mode [all|if0|if1|if2|if3|if4] = static
Example:
set ip-mode if2 dhcp
Response :
Interface 2 IP-mode set to dhcp
set tod
This command is new for version 2.0
This command controls whether or not TOD (Time of Day) output is generated on
the RS232 (serial) port. When set to enable, TOD is generated each second. TOD
format is controlled by the
set tod format command. When enabled, TOD is
unconditionally generated.
Syntax :
Set tod { enable | disable }
Example:
set tod enable
Response:
TP-500> T104592808102009FF0000012D020086
T104592908102009FF0000012D020014
T104593008102009FF0000012D0200DF
T104593108102009FF0000012D02004D
T104593208102009FF0000012D0200E2
T104593308102009FF0000012D020070
T104593408102009FF0000012D0200A5
T104593508102009FF0000012D020037
T104593608102009FF0000012D020098