Symbol AP-51xx, Product Reference Manual, Page: 326 / 622

AP-51xx Access Point Product Reference Guide 7-36
5. Click the Send Cfg to APs button to send the your access point’s configuration to other
access point’s. The recipient access point must be the same single or dual-radio model as
the access point sending the configuration. The sending and recipient access point’s must
also be running the same major firmware version (i.e., 1.1 to 1.1).
6. Click the Start Flash button to flash the LEDs of other access points detected and displayed
within the Known AP Statistics screen.
Use the Start Flash button to determine the location of the devices displayed within the
Known AP Statistics screen. When an access point is highlighted and the Start Flash button
is selected, the LEDs on the selected access point flash. When the
Stop Flash button is
selected, the LEDs on the selected access point go back to normal operation.
7. Click the Logout button to securely exit the access point Symbol Access Point applet. A
prompt displays confirming the logout before the applet is closed.
CAUTION When using the Send Cfg to APs function to migrate an access point’s
configuration to other access points, it is important to keep in mind
mesh network configuration parameters do not get completely sent to
other access points. The Send Cfg to APs function will not send the
“auto-select” and “preferred list” settings. Additionally, LAN1 and
LAN2 IP mode settings will only be sent if the sender’s AP mode is
DHCP or BOOTP. The WAN’s IP mode will only be sent if the sender’s IP
mode is DHCP.
!