Symantec 10521146 - Network Security 7120, Administration Manual

Page: 255 / 392

255 Managing log files
Exporting data
To configure this parameter
1 Click Configuration > Node > Network Security Parameters .
2 In Select Node , choose the node from the pull-down list, and click OK .
3 In the left pane, click under Log & Database Parameters , click Event Writer
File .
4 In the lower right pane, enter a value.
5 Click Apply .
6 In Apply Changes To , select the node to which to apply the parameter.
7 Click OK to save the changes to this node and close.
Note: Restart Symantec Network Security for changes to this parameter to
take effect.
Exporting to SESA
Symantec Network Security can export event data to Symantec Enterprise
Security Administrator (SESA) using the SESA Bridge Export node parameter.
You can install the Bridge to both software and appliance nodes by running the
Bridge installation script located in the
/usr/SNS/install/sesabridge
directory.
The SESA Bridge enables you to send events form Symantec Network Security to
the SESA management console. The Bridge is not required to use Symantec
Network Security in native mode.
This section describes the following topics:
■
Integrating with SESA
■
Setting SESA Bridge Export
Integrating with SESA
Symantec Network Security includes the capability to send security events to
SESA. You cannot configure Symantec Network Security from the SESA Console.
The installation procedure installs the SESA Bridge with Symantec Network
Security, so all have to do is enable exporting to SESA via the SESA Bridge
Export parameter.
You need the following:
■
Symantec Network Security installed on a dedicated computer, or Symantec
Network Security 7100 Series appliance