Safety and environmental instructions
Page 7/56
Programming instructions for
SYCLOPE EVASION
®
Except for the relay outputs, all connections inputs/outputs must be connected to very low
safety voltages.
In general, these voltages are provided by the controller and does not
exceed 15V continuous.
Make sure that the chemical sensors used with this device correspond well to the chemicals
used. Refer to the individual technical note of each sensor. Chemistry of water is very
complex, in case of doubt, contact immediately our engineering service or your approved
installer/reseller.
Chemical sensors are sensitive elements using consumable parts. They must be supervised,
maintained and calibrated regularly using specific calibrator systems not-provided with this
equipment. In the event of defect, a surplus possible hazard of chemical injections can be
noted. In the doubt, a service contract must be taken near your reseller/installer or failing
this near our engineering services.
Contact your approved installer/reseller or our business
service for more information.
4)
Labelling and localization of the identification plate
Label of the manufacturer
Particular risks. Read the notice
Model of the product
Product which can be recycled
Reference of the product
Limitation of dangerous substances
Range of power supply
EC compliance
Values of the maximum current
Country of the manufacturer
Class of protection
Manufacturer square code
Identification of the manufacturer
Conformity with the FCC part 15 Class B
Serial number
Identification plate
1
2
3
4
5
6
8
11
12
7
14
13
EVASION
Ref:
EVA 0000
90 - 240VAC 50/60Hz
www.syclope.fr Made in France
0,3 - 0,16A
IP65
S/N:
13044217
This device compiles with the Part.15 of the FCC rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation
9
10
15
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
