Specialist menu
Page 47/56
Programming instructions for
SYCLOPE EVASION
®
Selecting the parity of the communication port.
Selecting the address of the controller.
All controllers connected on the same RS485 bus must have the same speed, same parity
and each controller must have a different address to ensure a good communication.
c)
Remotes displays
This procedure allows you to define remotes displays. You must identify each remote display unit and
for each unit, you must define the parameters you want to screen.
The remote displays « Old generation » follow the COMPACT displays range made before
2011. It is possible to set 3 displays :
Temperature – pH – Chlorine A
Temperature – pH – Chlorine B
pH – Chlorine A – Chlorine B
The remote displays « New generation » follow the EVASION displays range made until
2011. It is possible to set 6 displays from adress 0 to 5. For every chanel sent, it is possible
or not to see if the chanel is in alarm.
►
Use the arrows keys to change the display number and validate.
►
Select the parameter you want to screen on each line and to validate.
RS232/RS485 mode
Transfer mode ....:RS485
Speed ............:19200
Parity ...........:
Without
Device number ....: 1
RS232/RS485 mode
Transfer mode ....:RS485
Speed ............:19200
Parity ...........:Without
Device number ....:
0
*
RS232/RS485 mode
Transfer mode ....:RS485
Speed ............:19200
Parity ...........:Without
Device number ....:
1
*
Without
**
Even
**
Odd
**
SPECIALIST MENU
Communications
Speed of printing
RS232/RS485 mode
> Remote displays
External modules
Infrared sensor
Modem
SPECIALIST MENU
Remote displays
> Old generation
New generation
