Safety and environmental instructions
Page 6/56
Programming instructions for
SYCLOPE EVASION
®
II.
Safety and environmental instructions
Please :
Read conscientiously the present notice before unpacking, installing and servicing the present
controller.
Take care of all risks and servicing before any use.
No respect of these instructions can cause damages to the users, the technical personal and the
integrity of the controller.
1)
Use of the controller
The
SYCLOPE EVASION
®
system has been designed to measure and regulate temperature, pH,
Redox potential, chlorine (or bromine), Ozone, PHMB, flow, Turbidity and Conductivity by means of
sensors and controls of suitable actuators in the context of the possible uses described in this manual.
All other uses are considered to be not conforming and must therefore be forbidden. SYCLOPE
Electronique S.A.S. will not be responsible in any case for any damages that result from such
uses.
Any use of sensors or interfaces not in conformity to the features defined in this manual
must also be proscribed.
2)
User obligations
The user undertakes not to allow its employees to work with the
SYCLOPE EVASION
®
equipment
described in this manual unless they:
Are aware of the fundamental instructions relating to work safety and prevention of accidents
Are trained in the use of the device and its environment
Have read and understood these instructions, warnings and manipulation rules.
3)
Risk prevention
The installation and connection of the
SYCLOPE EVASION
®
equipment should only be
performed by personnel specialized and qualified for this task.
The installation must comply with current safety standards and instructions!
Before switching the controller on or manipulating the relay outputs, remember always to cut
off the primary power supply!
Never open the controller when it is powered on!
Maintenance operations and repairs should only be performed by trained, specialized
personnel!
Take care when choosing the location for installing the equipment according to the
environment!
The
SYCLOPE EVASION
®
electronic box should not be installed in a hazardous environment
and should be protected against splashing with water or chemical products. It should be
installed in a dry, well-ventilated location, isolated
