SYCLOPE electronic HYDRO'Com HYD 7000, Installation And Commissioning Instructions, Page: 7 / 36

Environment and safety procedures Page 7/36
Installation and commissioning instructions manual
II. Environment and safety procedures
Please:
➢
Read this manual carefully before unpacking, installing or commissioning this equipment
➢
Take into account all the hazards and recommended precautionary measures
Failure to respect these procedures can result in serious injury to users or damage the device.
1) Use of the devices
HYDRO’Com ® communication devices have been designed to serve as a gateway to different
SYCLOPE Electronique products or other devices compatible in the context of the possibilities of
use described in this manual.
Any different use is considered improper and must be banned. SYCLOPE Electronique
S.A.S. will not assume any liability and the damages resulting therefrom.
Any use of sensors or non-compliant interfaces to the specifications defined in the operating
instructions must also be banned.
2) User obligations
The user undertakes not to allow its employees to work with the HYDRO’Com ® communication device
described in this manual unless they:
➢
Are aware of the fundamental instructions relating to work safety and prevention of accidents
➢
Are trained in the use of the device and its environment
➢
Have read and understood these instructions, warnings and manipulation rules
3) Risks prevention
The installation and connection of the HYDRO’Com ® communication gateway should only
be performed by personnel specialized and qualified for this task.
The installation must comply with current safety standards and instructions!
Before turning the device on or manipulating the relay outputs, please, always disconnect
the primary power supply!
Never open the appliance when powered on!
Maintenance operations and repairs must be performed by specialized and authorised
personnel!
Take care when choosing the location for installing the HYDRO’Com ® communication
gateway according to the environment!
The HYDRO’Com ® communication gateway should not be installed in a hazardous
environment and should be protected against splashing with water or chemical products. It
should be installed in a dry, well-ventilated location, isolated from corrosive vapors.
With the exception of the relay outputs, all connections inputs and outputs must be
connected to very low safety voltages. These tensions are generally provided by the device
and does not exceed 24VDC.