SYCLOPE electronic HYDRO'Com HYD 7000, Installation And Commissioning Instructions, Page: 23 / 36

Presentation and programming Page 23/36
Installation and commissioning instructions manual
6) Programming page
A simple click on logo allows to access to the programming page. During the loading of the page,
the application “MyHydro” requests a reading of the HYDRO’Com ® communication gateway
configuration. The programming page is shown as below:
The superior band allows to confirm the programming and to save all parameters into the device.
Allows to program the current configuration of the device.
Allows to save the current configuration into a .cfg file in case of
programming the device with a USB stick or to reload the same
configuration later using the “Import” function.
Allows to load a configuration from a .cfg file previously generated by the
“Export” function.
Allows to cancel a previous operation in progress.
When the configuration is established with
“ MyHydro ” application, the user can program the device
under two manners :
• Either in- line with the “Program” button : At the end of the programming phase, a message
appears for informing the user of the success or of the wrong operation.
• Either off-line with an USB stick : In this case, the user must export the configuration to the
USB stick and to connect it into the device when power supply is off, then… apply the power
supply when done. (See : Using USB stick)