SYCLOPE electronic HYDRO'Com HYD 7000, Installation And Commissioning Instructions, Page: 26 / 36

Presentation and programming Page 26/36
Installation and commissioning instructions manual
When all periods of time are programmed, the user must record the programming by clicking on
“Program” key.
10) Programming the slaves
The window of programming the slaves allows to declare the slaves devices connected to the
HYDRO’Com ® communication gateway.
The programming window is shown as below:
For connecting HYDRO Controllers, the user must specify if the first controller (i.e. The HYDRO
controller connected to the RS232C n°1) is activated or not. The same thing for the second HYDRO
controller.
For the other slaves connected to the RS485 bus, the user must specify if it is a SYCLOPE controller or
an UF gateway and must program the corresponding slave address.