11
20406039en_ba_e0
Connecting the charger
Before you can start using your charger you must first plug in the mains cable: Insert the
plug into the corresponding socket on the charger. Then insert the power supply in the
230 V socket. Place the handset on the charger (make sure that the batteries are insert-
ed!).
Note
• Your telephone will not function if the power supply is not plugged in or during a
power failure (no emergency mode).
• The cable must pass under the charger to assure its proper standing.
• Position the base station in a clean, dry and well-aired location. The ambient tempera-
ture must be b5°C and +40°C.
Safety note
Use only the following supplied power supply:
- MN-A002-A080 ; 7.5 V , 300mA from MEIC
Charging the batteries
The batteries are not yet charged when you first unpack the telephone. Insert the hand-
set in the charger. The flashing battery symbol on the handset shows the charging status.
The batteries will take around 14 hours to fully charge. Your handset is then ready to use.
Note
• For proper operation of the handset the batteries must be fully charged initially.
Socket for mains cable
Summary of Contents for Rousseau 300
