SWIR Acuros CQD Series, User Manual, Page: 18 / 121

User Manual
Acuros
®
CQD
®
Camera
18 | P a g e
4 Electrical Interfaces and Specifications
This section details the electrical connections for power and camera communications.
4.1 Specification and Camera Connectors
Interface Camera Connector Specification
Power Hirose
HR10A-10R-12PB (71) See details listed below
Trigger BNC Low level CMOS 3.3V
Unterminated
SN74HCT1G125 compatible
Ethernet RJ45 TCP/IP 1Gbps maximum
GigE Vision compatible
USB 10-pin USB 3.0 Micro-
B receptacle
USB Vision compatible
Table 2. Camera interface connector and specifications.
4.1.1 Power Specifications
Input Voltage Range: 6VDC minimum to 16VDC maximum.
Input Power Range: 6.5W minimum to 12W maximum
(depending on the amount of TE cooling required).
External Power Adapter: Rated 12V @ 2Amps
Allowable noise: 100mV ripple
Power over Ethernet (POE): POE is not supported and must not be connected.
4.2 Hirose pinout
A pinout of the Hirose connector is shown and described below. When building custom cable
assemblies, one must connect GND pin 1 and GND pin 5 to a common ground.
Figure 8. Hirose pinout diagram.