Swecoin TTP 5200, Service Manual

Page: 20 / 52

TTP 52x0 Series Kiosk Printer — Service Manual December 2001 18
REPLACEMENT
1. Install the cutter module in the reverse order. Make sure no cables are jammed
under the module. See page 40 for correct connector positions.
2. Check that there is a 0.2 – 0.5-mm distance at any point between the rear edge of
the presenter module and the cutting knife (you must manually turn the cutter-motor
so that the moving blade is in its lowest position when measuring). If necessary,
adjust by loosening the fixing screws of the print and cutter module assembly.
A too big distance might cause the paper running down between the cutter and the
presenter modules, and a too short distance will fold the paper in the rear edge of
the receipt.
Should the adjustment range be insufficient, also the cover plate of the presenter
module, and the presenter module position can be adjusted slightly.
Adjust distance!
Screws
SW96117A
Position cutter blade
in lowest position
Cover plate
Figure 8. Adjusting the distance between presenter motor and cutting knife